XKF4 XILINX FPGA KIT

Xilinx Virtex-4 XKF4 FPGA kit is a low cost, powerful and easy to use tool. Designed for rapid prototyping and implementing FPGA designs. Kit can be used for educational purposes. Kit can work independently, or as control module in the bigger design.

Features

1) XILINX XC4VFX60 FPGA

• 56880 Logic Cells
• 128 XtremeDSP Slices
• 232x 18Kb RAM blocks (4176Kb, 500MHz)
• 12 Digital Clock Managers
• 4 Ethernet MACs
• 2 PowerPC Processor Blocks
• 576 User I/O (251 routed on this board)

2) XILINX XCF32P FLASH

• 32Mbit Platform Flash PROM
• IEEE Standard 1149.1/1532 Boundary-Scan (JTAG) support for programming
• Endurance of 20000 Program/Erase Cycles

3) FTDI FT2232C USB controller

• Can be used as onboard USB JTAG programmer
• Can be used for communication in UART/FIFO/MPSSE modes
• Buffered port for programming external JTAG devices. Vref 1.65V -5.5V

4) Onboard IO peripherals

• 100MHz CMOS oscillator
• 8 LEDs
• 8 DIP switches
• Speaker
• 1 push button
• 128Mbit 133MHz SDRAM
• 16Gbit NAND FLASH
• 1024Kbit EEPROM

5) Handy configuration

• Configuration from onboard USB programmer
• Configuration from external programmer
• Mode select jumper (JTAG or FLASH)
• DONE LED
• Push button for manual initiation of configuration process
• Reset supervision by voltage monitor

6) Onboard power supply

• 3.3V 8A (IO, PERIPHERALS)
• 2.5V 1.5A (VCCAUX)
• 1.2V 30A (CORE VOLTAGE)
• 5V 1.5A (USB controller)
• 1.8V 1A (Platform FLASH)
• Input voltage range 11V – 13V
• POWER-ON LED
• AUX input for I/O voltage 1.14V-3.45V

7) 142 independent I/O routed to the connectors + additional outputs

• Two 5x13 male pin arrays (130 IO) with selectable IO voltage
• One 2x6 female connector (8 IO, 2 GND, 2 VCC 3.3V)
• One 1x6 female connector (4 IO, 1 GND, 1 VCC 3.3V)
• Peripheral modules support
• 2.54mm pitch for all connectors
• I²C header
• NAND FLASH header
• Test points for FPGA temperature diode

8) Small 100x100mm PCB with M3 mounting holes